I installed the right panel and mapbox, attaching the GPS 20A to the top of the mapbox.
I then started the Firewall forward wiring harness. This required a few wires to be put through the holes in the bottom of the panel. A little tricky with the transponder installed, but doable. Wires were then placed through grommet in firewall. The pitot tube pieces were then joined with a short piece of tubing and also placed through the firewall.
Battery, master relay, and manifold pressure sensor were then installed. The plans called for installed a starter relay, but I could not locate it. Later in doing some reading on vansairforce it was stated that it is with the engine. I will have to look for it next time.
Time: 2.5 hrs
 |
| Mapbox installed |
 |
| Right panel installed |
 |
| Battery |
 |
| Master relay, and Manifold pressure sensor |
 |
| Battery wire |
 |
| Firewall FWD harness |
 |
| Wires nicely tie wrapped |
No comments:
Post a Comment