Continued working on the midfuse skeleton. The fuselage latch pin was riveted to the arm rest and then the arm rest was installed on the fuselage. At this point I need to wait until tools arrive before I can make the longeron and proceed with the side skins.
I decided to start section 24 - Roll bar, so I prepared the roll bar parts and clecoed them together as per plans so the holes could be match drilled. The outside holes were then countersunk as per plans.
Time: 2 hrs
 |
| Fuselage pin latch |
 |
| Mid fuse skeleton |
 |
| Match drilling roll bar |
 |
| Countersinking rollbar |
 |
| Countersinking rollbar |
No comments:
Post a Comment