Worked on several sections today. I started by running the canopy latch and light wires. I then started section 35 - Landing gear. The doublers and wear plates were primed as per plans. I installed the brake fluid fittings to the landing hear blocks.I then regressed back to section 30 and prepared the spar pins as per plans. I tapped the pins without breaking them this time. Then with the help of S, N, and T we were able to try in the wings. It took a little adjustment but we were able to get the left wing to fit and the pins placed. The right wing took some more work. We had it very close to going in all the way, but it was getting cold so we will wait until another time to adjust it more. I will installed the landing gear and then we can try to place the wings again. It is getting to look more like and airplane with the wings installed.
Time: 3.75
 |
| Plastic tube over canopy latch and light switch |
 |
| Canopy latch and light wires ran |
 |
| Brake fitting attached to gear blocks |
 |
| Spar pins ready |
 |
| Trying in wings. |
No comments:
Post a Comment