Continued work on the fuel tank. I installed the fuel strainer. The fuel sender wire was bent per plans and the tested. I received a reading of 30 in the up position and 247 in the down position (The plans say approximately 30 in one position and 240 in the other). The fuel sender was temporarily installed to make sure the float is at the proper measurements. The mechanical gauge was installed. The neck flange and the fluid fitting were also installed.
Time: 2 hrs
 |
| Fuel Strainer |
 |
| Sender unit up position |
 |
| Sender unit down position |
 |
| Sender unit temp intalled |
 |
| Sender unit float |
 |
| Mechanical gauge, neck flange, fluid fitting installed |
No comments:
Post a Comment